![]() ![]() ![]() The output variable "demand setpoint temperature" in the heating circuit control is now also limited to the maximum flow temperature in frost protection mode.Cora device FTS: at high flow rate a wrong value was output (maximum value is outside the maximum allowed flow rate except for FTS DN8 and DN10).When accessing very slow or defective SD cards, the controller may restart.Controller sometimes restarts when accessing via CAN bus.Controller restarts occasionally when the GUI is busy for too long.In the mode “bank holiday” the derivative time had the intended effect on the date window, but not on the correct bank holiday date window. Changes in calendar function: In the modes “holiday” and “standby” in conjunction with derivative times, the begin of the date window is no longer brought forward, but instead the end of the date window.Fixed restarts connected to data logging to SD card.* "xxx" signifies the firmware version you are intending to update to and needs to be the same wherever mentioned. When updating a controller with a version below 1.04, the controller must receive an intermediate update to version 1.04 before updating to a higher version. ![]() To do so, drag the file “UVR16x2_Vxxx.bin” onto your UVR16x2 controller (under the tab “Data administration”).Īttention: Please update your C.M.I.’s firmware first. With a firmware version of 1.20 or above, the C.M.I. or in the directory /UVR16x2_Vxxx/ * on the SD-Card.or in the directory /UPDATE/ on the SD-Card.Preferably in the SD-Card’s root directory (not in any sub-folders).The update is to be initiated with the file “StartBSUpdate_Bxxx_UVR16x2_Vxxx”*. If the version of your UVR16x2’s firmware is below 1.20 and/or its bootsector below 1.05, two files are necessary on the SD-Card: “UVR16x2_Vxxx.bin”* and “StartBSUpdate_Bxxx_UVR16x2_Vxxx”*. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |